Hydrostatic Transmission - Titan TTK550LWM Owner's Manual

TTK550LWM by TITAN
Additional safety
• Use equipment marked "A".
Apply plates (1) to the two supporting brackets (2)
and (3), as shown in the figure.

Hydrostatic transmission

Make sure the release lever (7) is inserted in
the rear plate groove correctly and that it runs
freely.
Tighten screws (6).
FITTING THE DASHBOARD
AND STEERING WHEEL
• Use equipment marked "B".
Put the machine on a flat surface and
straighten the front wheels.
Fit the caster (3) on the steering column (2),
making sure the plug (1) is correctly fitted
into the caster seat.
Fit the steering column extension (3a) in the
hole in the caster (3).
Screw (4) the two brackets (2) and (3) to the
chassis supports, taking care they are in the
correct right and left positions.
Mount the lower part (5) of the rear plate and
screw (6) it to the lower brackets without
tightening the screws completely.
Before you start
GB
IE
13