Maintenance; Installation - ION 30ACi+ Operation Manual

30ACi+, 30ACi Deluxe,
35ACi+ and 35ACi Deluxe
Battery Backup System
of their capacity used before recharge. Available
in many sizes and types, be sure to use at least a
100AH battery.
BATTERIES NOT INCLUDED
B m
attery aIntenance
If you are using AGM maintenance free batteries
you do not need to perform any maintenance to
your batteries. For all other batteries refer to the
manufacturer recommended battery maintenance
section.
Maintenance or replacement of batteries should be
performed or supervised by personnel knowledgeable
of batteries and the required precautions.
r B
eplacIng attery
Wear full eye protection and protective clothing.
When replacing the battery/batteries, use the same
type and size battery/batteries. See left, Battery
Requirements.
DANGER: The electrolyte is a dilute sulfuric
acid that is harmful to the skin and eyes. It is
electrically conductive and corrosive. The following
procedures should be observed:
• Do not lay tools or metal objects on top of the
batteries
• Use tools with insulated handles
When Inverter is Operating on AC Power
1. Unplug the unit from the wall.
2. Follow the Installation Instructions of this
manual, starting with step 8 and working back
to step 1.
3. Remove and safely dispose of old batteries.
4. Install new battery, starting with Step 1 of the
Installation Instructions.
When Inverter is Operating on DC Power
1. Follow Steps 1 – 4 above.
Register your product at www.sumpro.com
OPERATION MANUAL
Dated: 02/10/2015
Document Name: 30-35ACi+&Deluxe_OM
2. Push and hold the Power button on the front of
the inverter for 3 – 5 seconds.
t n
oolS eeded
A pipe wrench, insulated pliers, insulated adjustable
wrench, and insulated screwdriver will be needed.
I I
nStallatIon
Remove all packing and contents from the battery
box enclosure. an inverter, battery box, pig tail with
Anderson connector, inverter power cord and pump
with vertical switch.
Find a suitable place to set the unit. Keep in mind that
the unit should be placed in a area where water and
moisture will not splash or drip on the unit, the fan inlet
on the sides of the enclosure will not be obstructed
and where a properly grounded three prong dedicated
receptacle is within reach of the power cord.
Remove watches, rings, or other metal objects.
Use tools with insulated handles.
Do not lay tools or metal parts on top of batteries.
1. Install the 12 volt deep cycle marine battery
into the plastic battery box. Make sure that the
MCB (main circuit breaker) on the back of your
inverter is in the OFF position.
2. Connect the black negative (-) wire of the pig
tail to the negative (-) terminal of the 12 volt
battery.
3. Connect the red positive (+) wire of the pig
tail to the positive (+) terminal of the 12 volt
battery.
4. Lay wires over the side of the battery box
so the Anderson connector is on the outside
of the battery box. Install the plastic cover
on the battery box so that the red and black
wires come out of the battery box and set the
inverter on top of the battery box cover.
5. Plug the Anderson connector from the inverter
into the Anderson connector from the battery,
insuring that the wire colors match on both
Page 4 of 12
nStructIonS