Heater Operation; Flame Operation; Setting The Time & Day (24 Hour Clock); Setting The Programmer - Stanley Argon Built In ARBI100 Installation And Operating Instructions Manual

Heater Operation

1. Press the Power Button to turn on the remote
control. The Screen will illuminate, the flame
picture on the unit illuminates and the Flame
Picture Icon will appear on the remote
control screen.
2. Press the Heater Button once to activate the
heater at full output (2kW). The Heater
Indicator will illuminate red on the unit and
the max heat indicator will be displayed on
the remote control screen (see Fig 7).
3. Press the Heater Button again to activate the
heater at half output (1kW). The Heater
Indicator will illuminate blue on the unit and
the half heat indicator will be displayed on
the remote control screen (see Fig 8).
4. Press the Heater Button for a third time to
turn the heater off.
The heating elements will only operate when the
temperature setting on the remote control is higher
than the ambient temperature in the room. The tem-
perature setting can be adjusted between 7 and 30°
C by pressing the Adjust + and Adjust - buttons.

Flame Operation

1. Press the Power Button to turn on the remote
control. The Screen will illuminate, the flame
picture on the unit illuminates and the Flame
Picture Icon will appear on the remote
control screen.
2. Press the Flame Button to turn off the flame
picture on the unit and the Flame Picture
Icon will be removed from the remote control
screen.
The colours of the Flame Picture can also be adjust-
ed using the Red, Yellow & Blue Flame Buttons. By
pressing one of these buttons, the level of the
choosen colour will reduce so that the desired flame
colour can be achieved.
Setting the Time & Day (24 Hour Clock)
1. Press the Power Button to turn on the remote
control.
2. Press the Shift Key and the Hour setting on
the remote control screen will flash. Adjust to
the desired setting by pressing the Adjust +
and Adjust - buttons.
3. Press the Shift Key and the Minute setting on
the remote control screen will flash. Adjust to
the desired setting by pressing the Adjust +
and Adjust - buttons.
Fig 7
Fig 8
Fig 9
4. Press the Shift Key and the Day setting on
the remote control screen will flash. Adjust to
the desired setting by pressing the Adjust +
and Adjust - buttons. (Monday = 1, Tuesday
=2, Wednesday = 3 etc.)

Setting the Programmer

The programmer allows for the unit to be set in two
operational modes (Heat & Flame Picture and
Flame Picture only) with hourly settings that can be
programmed for the full week. The programmer is
set as follows:
9
MAX HEAT INDICATOR
HALF HEAT
INDICATOR