Table of Contents
Advertisement
UP015DH(CLT5810) ENG OM
GETTING
C. Connect the base unit and charge the handset
1
Connect the AC adapter
to the DC IN 9V jack and
to a standard 120V AC
wall outlet.
2
Set the base on a desk
or tabletop, and place
the handset in the
base unit.
3
Make sure that the
CHARGE/IN USE LED
illuminates.
If the LED does not illuminate, check to see that the AC adapter
is plugged in and the handset makes good contact with the base
charging contacts.
Notes:
• Connect the AC adapter to a continuous power supply.
• Place the base unit close to the AC outlet so that you can unplug the AC
adapter easily.
IMPORTANT
• Use only the supplied Sanyo AC adapter. Do not use any other AC adapter.
• Do not place the power cord so that it creates a trip hazard or where it could
become damaged and create a fire or electrical hazard.
3/9/05
10:36 AM
STARTED
Route the cord.
Page 7
E7
Advertisement
Table of Contents
