Optical Wear Plate And Side Wear Plate Replacement - Veris U3 Operating Instructions Manual

Pub# OM20-U3-pH
Procedure #9: Optical Wear plate and Side Wear plate replacement.
1. Remove the two ½" nuts on top edges of i-Scan side plate
2. Remove the two Torx screws attaching the side plates to the
1
runner. (Figure 9.1)
3. To remove wear plate, unscrew the hex bolts on the top of the
2
optical sensor as shown in figure 9.2
4. To replace the wear plate, ensure the
O-ring is seated in the O-ring grove as shown
in figure 9.3.
5. Install the wear plate, then mount the assembly back to the row
unit. Do not allow any dust or moisture to enter the optic
module.
Figure 9.1
Figure 9.2
Figure 9.3
6-17