Veris U3 Operating Instructions Manual page 35

5) Raise sampler into top position and press manual wash switch. Check to see if both electrodes are
being sprayed correctly for cleaning. (figure 11)
6) If necessary, adjust by loosening set screws and re-adjusting. (figure 12)
7) Raise sampler to top position, switch to Automatic, and you are ready to begin mapping.
Sampler will now lower every time you stop in the field. Information on sampling density and swath
width is covered in Section 4.
Figure 11
Figure 12
5-8
RH wash jet is
focused on rear
electrode
LH jet is focused on
front electrode
Pub# OM20-U3-pH