Pulling Vehicle; Swath Width And Navigation - Veris U3 Operating Instructions Manual

Ec/om/ph

Hide thumbs Also See for U3:

Table of Contents

Pulling Vehicle

The implement may be pulled with a variety of vehicles: UTV, 40 hp tractor or a 4WD pickup.

Setting the swath width and navigation system is at the discretion of the customer. A 50'-75' (15-23 m)

swath works well in most areas. Several methods of navigation are possible: following previous crop rows,

swath guidance, or auto-steer. While it is important to map in a consistent pattern, it isn't absolutely critical

that each pass be exactly the same distance from the previous pass.

To help insure the quality of your data, please follow these guidelines:

View SoilViewer map frequently during data collecting; watch for:

• Negative EC readings or excessive noise in the data.

• EC readings should fluctuate gradually as you drive across the field, relating to

soil changes. If readings change erratically, or show values not typical of soil

conductivity in the area—such as >100, perform tests 4 and 5 below.

• Watch for streaks, stripes, unnatural patterns, and missing data points.

Perform Signal test (Procedure #3):

• at least once a day during mapping season

• every 10 hours of mapping

• after extended periods of non-use

• after replacing or repairing coulter-electrode components or wiring

• whenever readings are questionable

Keep all electrical connections dirt and moisture-free

Limit speeds in rough or rocky field conditions. This will improve data quality, and will also lengthen the

service life of the implement components. NEVER EXCEED 15 M.P.H. FIELD SPEED.

• Be very careful when mapping stubble fields with a gasoline engine. Be prepared if

a fire starts.

5-2

Pub# OM20-U3-pH

Table of Contents