Computer Display Adjustment - Sanyo VMC-L1015 Instruction Manual

Computer display adjustment

: Adjustment method for VGA signal selection
Operation
MENU AUTO MODE POWER
MENU
1 2 3
Adjustment item
Item
Brightness Adjust the brightness.
Contrast Adjust the contrast.
H-Position* Adjust the horizontal position of the display.
V-Position* Adjust the vertical position of the display.
Adjust the clock (when vertical lines can be seen etc.).
Clock*
• Make fine adjustments until the vertical lines disappear. Adjusting the
clock will also change the width of the display.
Phase* Adjust the phase (when the screen is flickering, etc.).
Color Temp. Select the color temperature.
User Color R Adjust the Red (when Color temp. is set to User color).
User Color G Adjust the Green (when Color temp. is set to User color).
User Color B Adjust the Blue (when Color temp. is set to User color).
OSD H-Pos. Adjust the horizontal position of the adjustment panel.
OSD V-Pos. Adjust the vertical position of the adjustment panel.
Volume Adjust the volume.
Select to use Picture in Picture, showing an additional smaller
PIP
display in the upper left corner.
Language Select the language of the adjustment panel.
Pressing the +, – buttons together will return the settings to the
Recall
default value.
* Use this when pressing the automatic display adjustment control (AUTO) (page 5) does not achieve the desired result. Also, by pressing the
automatic display adjustment control (AUTO), these values will be changed.
• The settings will be retained even if the unit is switched off, but if the power supply is disconnected, settings will return to default.
• The default language display is English. If the language setting is changed, the menu display will be in the language chosen.
1
Press the adjustment control (MENU).
R At the top of the screen, an adjustment panel as
shown in the diagram to the right will be
displayed.
2
Choose the adjustment item.
Down Up
3
Change the setting value.
4
If necessary, repeat steps 2 and 3.
• Pressing the adjustment control (MENU) again, or waiting for a number of seconds will cause
the adjustment panel to disappear.
Description
– 7 –
Adjustment item
VGA IN
Brightness
Contrast
H-Position
V-Position
Clock
Phase
Color Temp.
User Color R
User Color G
User Color B
OSD H-Pos.
OSD V-Pos.
Volume
PIP
Language
Recall
Parameters Default setting
0 – 51
0 – 51
0 – 51
0 – 51
0 – 51
0 – 51
° °
9300 K, 6500 K,
User color
0 – 51
0 – 51
0 – 51
0 – 51
0 – 51
0 – 51
Composite, S-Video,
Component, Off
English, Chinese,
French, German,
Spanish, Italian,
Japanese
–
Setting value
1024x768@60Hz
25
25
25
31
25
13
User color
51
51
51
25
25
30
Off
English
25
25
25
31
25
13
User color
51
51
51
25
25
30
Off
English
–