Adjustment; Before Adjustment - Sanyo PDP-42H1EV Service Manual

I Adjustment
The each circuit has been made by the fine adjustment at factory. Do not attempt to adjust
the following adjustments except requiring the readjustments in servicing otherwise it may
cause loss of performance and product safety.

Before Adjustment

This adjustment is done to enter Service Mode by Remote
Control Unit.
I To enter Service Mode
Quick operation is needed to enter Service Mode.
(1) Turn the monitor on.
(2) Press and hold the MENU button on the monitor.
(3) Keep item (2) and press the STATUS button and
release the both buttons.
(4) Within 2 seconds after item (3), press the MUTE
button to appear the Service Mode Display.
I Service Mode Display
Av-Dynamic
0 Cont
I To return to the Normal Mode
Once turn the Monitor off by pressing "POWER" button on the monitor or remote control unit and turn it on again.
CAUTION
63 (3F)
42H1
Main
103
Sub
040
MENU Button
OK
INPUT
MENU VOLUME
(←) / (→)
To select :
Adjustment Item
or Data Setting
INPUT
VIDEO COMPONENT
PC/RGB
OFF TIMER
PICTURE MOVE UP
STATUS
To enter
F
Service Mode
STATUS
MUTE
-15-
(↑)
G

Adjustment :

UP
ON-OFF
G
Data Setting
VOLUME
+
( )
(↓)
MUTE
G
Adjustment :
DOWN
OK
G
Data Setting
MENU
–
( )
POWER
ON
OFF