Instructions For Use - Sanyo VMC-L1015 Instruction Manual

Instructions for use

1 1 1 1
Switch the power button (POWER) on.
R The power indicator light will light up.
POWER
Power indicator light
2 2 2 2
Press the input mode control (MODE) and
choose the input signal.
MODE
• Press once and the currently selected signal will be
displayed. Press again and the available signal
options will be displayed in the order shown below.
(The symbol for selected option will be displayed in
the upper left of the screen.)
: Composite signal (BNC IN)
: S-Video signal (Y/C IN)
: VGA signal (VGA IN)
: DVI signal (DVI IN)
Cannot be used
: Component signal (Y, Cb, Cr IN)
Cannot be used
• When the signal is changed, initially a blue screen
will be displayed, followed by the display of the
chosen signal 2-3 seconds later.
• When there is no input detected on the chosen
signal, "NO SIGNAL" will be displayed.
• If the power to the connected device is off, "VIDEO
LOSS" will be displayed.
2
A
3 4
B
MENU AUTO
3 3 3 3
4 4 4 4
5 5 5 5
– 5 –
2
1 5
MODE POWER
Adjust the brightness (
Decrease
• As the brightness is being adjusted, the
will be displayed in the upper left of the screen.
Adjust the contrast (
Decrease
• As the contrast is being adjusted, the
will be displayed in the upper left of the screen.
A
Adjust the volume [0 – 51].
Decrease Increase
• As the volume is being adjusted, the
symbol will be displayed in the upper left of the
screen.
B
Screen automatic adjustment
(For VGA signal)
AUTO
R The clock, phase and screen position are
automatically adjusted according to the
specified input signal.
When viewing is finished, press the
power button (POWER).
R The power indicator light will go out.
) [0 – 51].
Increase
symbol
) [0 – 51].
Increase
symbol