Automatic Ice & Water Dispenser - Frigidaire BASELINE Series Use & Care Manual

AUTOMATIC ICE & WATER DISPENSER
Priming the water supply system
CAUTION
For proper dispenser operation, recommended
water supply pressure should fall between
30 psi and 100 psi. Excessive pressure may
cause the system to malfunction.
1 Begin filling the system by pressing and
holding a drinking glass against the water
dispenser
paddle.
2 Keep the glass
in this position
until water
comes out of
the dispenser.
It may take
about 1½
minutes.
3 Continue
dispensing
water for
about four
minutes to flush the system and plumbing
connections of any impurities (stopping to
empty the glass as necessary).

NOTE
The water dispenser has a built-in device that
shuts off the water flow after three minutes
of continuous use. To reset this shutoff de-
vice, simply release the dispenser paddle.

NOTE
Dispensed water is not chilled. For colder
water, add ice to cup or container before
dispensing water.
Ice maker operation & care
After the refrigerator is installed properly and
has cooled for several hours, the ice maker can
produce ice within 24 hours. The ice maker will
fill the ice bin from the rear. You must dispense
some ice to force the ice forward in the bin.
This will allow the bin to fill completely.
Ice Maker and Storage Bin Capacity
This ice maker should produce 2.0 to 2.5
pounds of ice per 24 hours.
In a Standard Depth model, the ice bin will hold
about 6.5 pounds of ice. In a Counter Depth
model, the ice bin will hold about 4 pounds of ice.
26
Dispenser
(varies by model)
Turning the fresh food ice maker
on and off
Ice production is controlled by the ice maker's
On/Off feature on the control panel. Pressing
the On/Off feature turns the ice maker on &
off.
IMPORTANT
Turning off the ice maker simply disables
ice making. You will still be able to dispense
existing ice, and you will still be able to
dispense water.

NOTE
The ice maker also has a built-in plastic
signal arm that automatically stops ice pro-
duction when the ice bin is full. This signal
arm should not be used to manually stop
the ice maker.
Using the ice maker after installation
Before making ice for the first time, be sure
to prime the water supply system. Air in new
plumbing lines can result in two or three empty
ice maker cycles. Furthermore, if the system
is not flushed, the first ice cubes may be
discolored or have an odd flavor.
IMPORTANT
Your ice maker is turned on at the factory so
it can work as soon as you install your refrig-
erator. If you cannot connect a water supply,
set the ice maker's On/Off feature to Off;
otherwise, the ice maker's fill valve may make
a loud chattering noise when it attempts to
operate without water.
IMPORTANT
On occasion, unusually small ice cubes may be
noticed in the bucket or in dispensed ice. This
could occur in normal operation of the ice mak-
er. If you start seeing these more frequently,
it may be an indication of low water pressure
or the water filter needs to be replaced. As the
water filter nears the end of its useful life and
becomes clogged with particles, less water is
delivered to the ice maker during each cycle.
Remember, if it's been six months or longer
since you last changed your water filter, replace
the water filter with a new one. Poor quality
household water may require the filter to be
changed more frequently.