Batteries; Removal/Replacement Of Battery Pack - Minelab Quattro MP User Manual

4. Batteries

The Minelab Quattro MP has both Alkaline and NiMH battery
packs available as either standard or accessory items.
The NiMH 1600 mAh battery pack will power the detector for up to
12.5 hours of constant use and the NiMH 1800 mAh battery pack for
14 hours.
Eight good quality, fresh, 1.5V AA alkaline batteries will power the
Quattro MP for up to 14 hours of constant use.
Unlike Nickel Cadmium batteries, the NiMH battery pack DOES NOT
have to be discharged before recharging. Whenever the detector has
been unused for a lengthy period, recharge the battery pack to ensure
full performance. There is no limit to the time the battery pack can be
left on charge.
Removal instructions apply to both types of battery packs.
4. Removal/Replacement
1.
of Battery Pack
To Remove the Battery Pack:
1. Turn Detector off.
2. Lift the rubber cap of the battery handle assembly.
3. Raise the yellow tab. This releases the spring-loaded
battery pack.
4. Remove battery pack from handle assembly.
To Replace the Battery Pack, slide the pack into the
compartment until it 'clicks' into place.
4. Inserting Alkaline Batteries
2.
1. Slide back the sliding door of the alkaline battery pack in the
direction of the arrow.
2. Install 8 good quality fresh AA alkaline batteries in the direction
of the arrows located inside the battery pack
3. Close the sliding battery door and re-install into
battery handle compartment.
4. batteries
www.minelab.com
p9