Table of Contents
Advertisement
Check the status of projector
In the "Power & Status" page, you can control the projector power, and also you can
check the status of the projector as follows:
Items
Accumulated lamp-use time
Accumulated projector-use time
Power status
Projector condition
Input status
Internal temperature
The icons [A], [B] and [C] rep-
resent the sensors located in
the projector as follows:
[A]: Surrounding temperature
of the projector *
[B]: Surrounding temperature
of the lamp
[C]: Surrounding temperature
of the panels
* The indicated peripheral
temperature of the projector
is a little higher than actual
surrounding temperature.
Description
It displays in 1 hour units (h)
When resetting the lamp counter, this time will be reset to 0.
It displays the accumulated used time in an hour unit (h). This
cannot be reset.
It displays the status of the lamp, OFF, On starting up, ON, On
cooling down.
It displays the condition of the projector's power, Normal,
Power Failure, Temperature Error, Normal after temperature
over, On Power management working.
It displays the selected input mode, signal mode and signal
status.
It displays the temperature at internal thermal sensors in
degrees. The icons [A], [B] and [C] on the page represent the
thermal sensors located in the projector. If the temperature at
one of those sensors exceeds specified temperature, the
appearance of its icon changes to the following alert icon to let
users know about the abnormal temperature. Please check
surrounding temperature of the projector, check for clogged air
filters and check area surrounding the ventilation fans.
Power on/off the projector
Network Unit
OWNER'S MANUAL
37
Advertisement
Table of Contents
