Configure The Network With The Computer - Sanyo PJ-NET ORGANIZER POA-PN10 User Manual

Installation

Configure the network with the computer

B
This example explains how to set the following configuration.
IP Address
Subnet Mask
Default Gateway : 192.168.1.1
DNS
The default network configuration is set as follows.
IP Address
Subnet Mask
Default Gateway
DNS
Make sure that the projector is connected to the network and then connect the AC
cord to the outlet.
1
Temporarily*
group number as the Network Unit. For example, change your computer network
configuration as follows and restart the computer.
IP Address
Subnet Mask
Default Gateway
DNS
The network configuration of computer differs depending on each network environ-
ment or your computer. For further information, please see the next chapter
"Configure the network of computer".
*1 Change your computer's network configuration temporarily. After completing the set up for
the projector, you must set up again to the original network configuration for your computer.
It is recommended to make a note of those network settings.
18
: 192.168.1.201
: 255.255.255.0
: 0.0.0.0
: 192.168.0.2
: 255.255.255.0
: 0.0.0.0
: 0.0.0.0
set up your computer network configuration to the same IP network
1
: 192.168.0.5
: 255.255.255.0
: (blank)
: (blank)
PO W ER