Table of Contents
Advertisement
Controlling the Projector
The setting items and their operations are listed below.
Setting items
Language
Keystone
Blue back
Display
Logo
Ceiling
Rear
No Show
Freeze
Power Management
On Start
Timer Setting
Remote Control
Lamp Counter Reset
Lamp Mode*
P-TIMER
[Note]
*1 This popup window is realized by using the JavaScript function of web browser. If the prefer-
ence of the browser is set not to use the JavaScript, the lamp counter is reset immediately
without displaying the popup window for confirmation. To display the confirmation window,
please change your preference to use the JavaScript function.
There are various kind of ways to change this preference depending on the web browser's
version and application. Please refer to chapter "Appendix: Web browser setting/Active
Script (JavaScript enable)" on page 68.
44
Operation
Select the language used in the on-screen menu of the projector. Select your
desired language with the pull down menu button, and then press the Set button.
Correct the distortion of the projected image with the Left, Right, Up and
Down buttons. To cancel the keystone correction, press the OFF button.
When this setting is ON, the projector displays a blue image when no input
signal is selected.
This setting is to select whether to display the on-screen display menu.
When this setting is ON, the projector displays a logo when starting up.
When this setting is ON, the picture is reversed top/bottom and left/right.
When this setting is ON the picture is reversed left/right.
When this setting is ON the picture on the screen is black out.
When this setting is ON, the picture on the screen is frozen.
When this setting is ON, the projector will automatically turn the lamp off if the
input signal is interrupted and no control button is pressed for 5 minutes and
30 seconds. Set OFF to disable this function.
When this setting is ON, the projector is automatically turned on just by con-
necting the AC power cord to a wall outlet.
Turns the projector on or off at a preselected day/date and time. Please see
chapter [Timer Setting] on the next page for more information.
8 different remote control codes can be set. Must be set the same code num-
ber with the remote control when this code is changed.
This is used to reset the lamp-use time. When replacing the lamp, reset the
lamp-use time by pressing the Yes button. Another popup window*
appear for confirmation and then press the Yes button to reset.
This is used to switch the lamp mode. When
reduces the brightness and sets into the low power consumption mode.
* Some projectors may not have this menu.
When P-TIMER button is pressed, the timer display "00:00" appears on the
screen and timer starts to count the time (00:00 ~ 59:59). To stop the time
counting, press P-TIMER button and press this button again to cancel the P-
TIMER function. The status is changed as ON -> STOP -> OFF when this but-
ton is pressed repeatedly.
Eco
is selected, the projector
will
1
Advertisement
Table of Contents
