Xerox VersaLink C9000 User Manual page 245

• Always Allowed: The device powers off automatically after the specified time, and the cumulative
Low Power mode and Sleep mode timeouts have elapsed.
• Allowed ONLY When Conditions are Met: The device automatically powers off only after time-
outs have elapsed. The device also powers off if Fax, USB Drive, and Wired and Non-Wired Net-
work have not been activated.
To change the Power Saver settings, refer to the User Guide at
or www.xerox.com/support/VLC9000docs. For further assistance, contact your System Administrator
or refer to the System Administrator Guide.
To enable Auto Power Off mode, contact your System Administrator. For details, refer to the System
Administrator Guide at
VLC9000docs.
To learn more about Xerox participation in sustainability initiatives, go to:
xerox/environment/enus.html
Note: Changing the default Power Saver activation times can result in an overall higher energy
consumption of the device. Before you turn off Power Saver modes or set a long activation
time, consider the increase in device power consumption.
Default Power Saver Settings
This device is ENERGY STAR
Equipment. The transition time from Ready mode to Low-Power mode can be set up to 60 minutes.
The default value is 10 minutes. The transition time from Low-Power mode to Sleep mode can be set
up to 60 minutes. The default value is set at 1 minute. The total transition time from Ready mode to
Sleep mode can take up to 60 minutes.
To change the Power Saver settings, contact your System Administrator, or refer to the System Admin-
istrator Guide at:
• Xerox ® VersaLink ®
• Xerox ® VersaLink ®
Environmental Benefits of Duplex Printing
Most Xerox products have duplex printing, also known as 2-sided printing, capability. This enables you
to print on both sides of the paper automatically, and therefore helps to reduce the use of valuable re-
sources by reducing your paper consumption. The Lot 4 Imaging Equipment agreement requires that
on models greater than or equal to 40 ppm color or greater than or equal to 45 ppm monochrome
the duplex function has been auto-enabled, during the setup and driver installation. Some Xerox mod-
els below these speed bands may also be enabled with 2-sided printing settings defaulted on at the
time of install. Continuing to use the duplex function will reduce the environmental impact of your
work. However, should you require simplex/1-sided printing, you may change the print settings in the
print driver.
Paper Types
This product can be used to print on both recycled and virgin paper, approved to an environmental
stewardship scheme, which complies with EN12281 or a similar quality standard. Lighter weight paper
(60 g/m²), which contains less raw material and thus saves resources per print, may be used in certain
applications. We encourage you to check if this is suitable for your printing needs.
www.xerox.com/support/VLC8000docs
or www.xerox.co.uk/about-xerox/environment/engb.html.
® -qualified under the ENERGY STAR Program Requirements for Imaging
8000 Color Printer: www.xerox.com/support/VLC8000docs
9000 Color Printer: www.xerox.com/support/VLC9000docs
www.xerox.com/support/VLC8000docs
or www.xerox.com/support/
Xerox ® VersaLink ® C8000/C9000 Color Printer
Regulatory Information
www.xerox.com/about-
User Guide
245