Table of Contents
Advertisement
Installation Information
INSTALLATION PROCEDURE
•
Insert cooktop into countertop opening and center
cooktop. Check that the front edge of the cooktop is
parallel to the front edge of the countertop. Check
that all required clearances are met.
•
Use a pencil to outline the rear of the cooktop on
the countertop. Then remove cooktop from coun-
tertop.
•
Apply foam strip around bottom of burner box flush
with the edge
(See Figure
•
Reinsert cooktop into the countertop opening.
Check that the cooktop is parallel to the front edge
of the countertop. Lift the entire cooktop to make
adjustments, aligning with the pencil line.
•
Attach brackets to the burner box. Insert the
clamping screws into the brackets. Use a screw-
driver to tighten clamping screws against the under-
side of the countertop
NOTE:
Do not overtighten screws.
•
Install the pressure regulator with the arrow on the
regulator pointing up towards the unit and in posi-
tion where you can reach the access cap
Figure
3-9).
•
Assemble the flexible metal connector from the gas
supply pipe to the pressure regulator
3-10).
•
Use a pipe-joint compound made for natural and
LP gas. If a flexible connector is used, be certain
the tubing is not kinked.
NOTE:
All connections must be wrench tightened.
Do not make the connections to the regulator too
tight. Making the connections too tight could crack
the pressure regulator. Do not allow regulator to
turn on the pipe when tightening fittings.
•
Open the shut-off valve in the supply line. Wait a
few minutes for the gas to move through the line.
•
Leak testing of the appliance shall be conducted
accordingly using a soapy water solution or an
electronic leak detector.
NEVER USE OPEN FLAMES TO CHECK FOR GAS
LEAKS. ONLY USE A LEAK TESTING SOLUTION
OF SOAPY WATER OR AN ELECTRONIC LEAK
DETECTOR. DO NOT USE LIQUID NEAR VALVE
STEMS.
The maximum gas supply pressure to the regulator
should never exceed 14" WC (Water Column
Pressure); 1/2 psi (3.5kPa).
#802985 - Revision E - August, 2011
Gas Cooktop (CTG) Series
Gas Cooktop (CTG) Series
3-8).
(See Figure
3-8).
(See
(See Figure
Cooktop Pan
Burner Box
Figure 2-8. Foam Strip
Cooktop Pan
Burner Box
Bracket Screws
Figure 2-9. Holding Clamp
Rear of Burner Box
Figure 2-10. Regulator Flow Arrow
Manual
Shut-off Valve
1/2" Adapter
Flexible Metal Connector
1/2" Nipple
(use pipe-joint compound)
Figure 2-11. Gas Connection
2-6
Foam Strip
Countertop
Bracket
3" (6.4cm)
Clamping Screw
Regulator
Gas Flow
Arrow
Points Up
Pressure
Regulator
1/2" Adapter
1/2" Nipple
(use pipe-joint compound)
Advertisement
Table of Contents
