Table of Contents
Advertisement
Component Access & Removal
Spark Electrode Removal
The surface burner electrode is inserted down through
the inner distribution ring. It is held in place by a retain-
er clip, which is inserted into the mounting hole in the
cooktop pan. When the spark electrode is inserted fully
through the inner distribution ring and the cooktop pan,
the retainer clip holds the electrode down tight. In order
to remove the spark electrode, the burner head will
need to be removed. Now, pull the spark electrode up
through the hole in the inner distribution ring and unplug
the lead wire from the electrode
NOTE:
If just removing the top portions of one or two
of the surface burner components without removing the
cooktop pan, use a small piece of electrical tape and
secure the electrode wire to the top of the cooktop pan.
This will make re-connecting the electrode wire to the
electrode easier when reinstalling.
Inner Distribution Ring Removal
The inner distribution ring routes the gas from the sim-
mer orifice hood to the simmer holes located in the
burner head. To remove the inner distribution ring, the
preliminary steps must be followed first. Now, remove
the electrode and the venturi. Then, lift the inner distri-
bution ring from the cooktop pan, being careful not to
lose the O-ring which is mounted in a groove in the
underside of the inner distribution ring. This O-ring pro-
vides the seal between the cooktop pan and the inner
distribution ring
(See Figure
Cooktop Pan Removal
In order to remove the cooktop pan you will need to
remove the burner valve control knobs. Then, remove
the surface burner grates, burner heads w/caps, ven-
turi, electrodes and inner distribution rings. Now the
cooktop pan can be lifted straight up and off of the
burner box
(See Figure
NOTE:
It may be necessary to remove the entire cook-
top from its installation before removing any of the sur-
face burner components. This will make the alignment
of the distribution rings and O-rings easier when rein-
stalling the surface burner components and the cooktop
pan.
#802985 - Revision E - August, 2011
(See Figure
4-3).
4-4).
4-5).
Gas Cooktop (CTG) Series
Gas Cooktop (CTG) Series
Figure 4-3. Spark Electrode Removal
Figure 4-4. Inner Distribution Ring Removal
Figure 4-5. Cooktop Pan Removal
4-4
Advertisement
Table of Contents
