Filler Strip Installation Procedure - Wolf 2 Series Technical & Service Manual

G G A A S S C C O O O O K K T T O O P P - -
G G A A S S C C O O O O K K T T O O P P - -

FILLER STRIP INSTALLATION PROCEDURE

These instructions contain procedural information to install the Integrated Filler Strip Kit into countertop installations.
1. Locate center of Filler Strip Bracket (2) at required distance from cooktop cutout edge.
2. Position Filler Strip Bracket (2) so that top surface is flush with counter top. You may need a
straight edge to assist in locating bracket at correct height.
3. Mark center of elongated slots of Filler Strip Bracket (2) on front and rear of cooktop cutout.
4. Using a 3/32" drill bit, drill a ¾" deep pilot hole for the #6/32 (3) mounting screws.
5. Secure Filler Strip Bracket (2) to counter top.
PLEASE CONSULT WITH THE COUNTERTOP MANUFACTURER/INSTALLER FOR THE PROPER METHOD OF
INSTALLING SCREWS INTO THE INSIDE EDGE OF THE COUNTER TOP. DAMAGE MAY OCCUR IF THE
PROPER METHODS ARE NOT USED.
6. Install all cooktops into corresponding openings.
7. Position Filler Strip (1) into Filler Strip Bracket (2) and install three #10-24 nuts (4), but do not tighten.
8. Align and adjust cooktops and filler strips in countertop opening and then tighten cooktop hold down
clamps and filler strip nuts.
14
5/8"
Fig. 3-12. Filler Strip with Three Integrated Cooktops, Typical Installation.
14
5/8"
Fig. 3-13. Filler Strip with Two Integrated Cooktops and a 30" Gas or Electric Cooktop, Typical Installation
2 2
2 2
1
2
15
1/4"
44
1/2"
1
2
15
1/4"
59
1/2"
3-7
S S E E R R I I E E S S
S S E E R R I I E E S S
3
4
14
5/8"
3
4
29
5/8"
Installation Information