Table of Contents
Advertisement
Installation Information
SUPPORT KIT FOR DOWNDRAFT INSTALLATION PROCEDURE
These instructions contain procedural information to install the Integrated Cooktop Support Kit for downdraft ventila-
tion installations.
NOTE:
This kit does not include the Filler Strip Kit Assembly. Please order Kit Model number: 803386.
1. Locate and center the Rear Bracket Support (1) in the downdraft cutout as shown.
2. Position the Rear Bracket Support (1) so that the top surface is flush with the counter top. You may need a
straight edge to assist in locating the bracket at the correct height.
3. Mark the center of the elongated slots of the Rear Bracket Support (1) at both ends on the countertop.
4. Mark the center of the elongated slots of the Filler Strip Bracket (not included) on the front of the cooktop cutout.
5. Using a 3/32" drill bit, drill a 3/4" deep pilot hole for the #6/32 mounting screws (3)
PLEASE CONSULT WITH THE COUNTERTOP MANUFACTURER/INSTALLER FOR PROPER METHOD OF
INSTALLING SCREWS INTO INSIDE EDGE OF COUNTERTOP. DAMAGE MAY OCCUR IF PROPER METHODS
ARE NOT USED.
6. Install the Downdraft into the countertop opening, but do not secure in place at this time.
7. Secure the Rear Bracket Support (1) and Filler Strip Bracket (not included) to the countertop using items (2 & 3).
8. Install Integrated cooktops into the corresponding openings.
9. Position the Filler Strip (not included) into the Filler Strip Bracket (not included) and install the three #10-24
nuts, but do not tighten.
10. Align and adjust cooktops, downdraft and filler strip in the counter top opening and then tighten cooktop hold
down clamps, filler strip nuts and secure the downdraft per installation instructions.
#802985 - Revision E - August, 2011
Gas Cooktop (CTG) Series
Filler Strip
Not Included
CENTER OF
CUTOUT
Figure 2-14. Support Kit for DownDraft Ventilation Installation.
Gas Cooktop (CTG) Series
1
2
3
Not Included
2-8
(Refer to 2-14 Below)
Filler Strip Bracket
Not Included
2
Advertisement
Table of Contents
