Table of Contents
Advertisement
Gas Cooktop (CTG) Series
Gas Cooktop (CTG) Series
Component Access & Removal
Spark Module Removal
NOTE:
It is recommended to note and label the elec-
trode wire locations before removing a spark module.
To remove the spark module, you first need to follow
the preliminary steps listed at the beginning of this sec-
tion. Disconnect the wires from the spark module.
Then, extract the module mounting screws and pull the
module from the support plate
(See Figure
4-9).
Spark Module Support Plate
The spark module support plate is mounted to the burn-
er box with screws. To remove the spark module sup-
port plate, follow the preliminary steps listed at the
beginning of this section first. Now, extract the screws
that secure the support plate and lift off
(See Figure 4-
9).
Figure 4-9. Spark Module & Support Plate Removal
Lead Wire Removal
The lead wire is connected to the spark module and the
spark electrode. To remove the lead wire, follow the
preliminary steps listed at the beginning of this section
first. Now, unplug the lead wire from the terminal con-
nection at the spark module and lift the lead wire out.
Power Cord with Grip Removal
To remove the power cord, follow the preliminary steps
listed at the beginning of this section first. Next, unplug
the power cord plug connector at the harness. Now,
extract the screw that secures the ground terminal of
the power cord to the burner box. Squeeze the tabs of
the grip connector (grip connector secures the power
cord to the burner box) and pull the power cord down
through the opening and out of the burner box
(See
Figure
4-10).
Figure 4-10. Power Cord Removal
4-7
#802985 - Revision E - August, 2011
Advertisement
Table of Contents
