Relay Module Installation - Bennett Marine BOLT129 Installation & User Manual

Relay Module Installation

BCN6500
Installation Steps
Note: Relay module installation is not required for BRC installations
(See wiring diagram beginning on page 24).
• Find a suitable dry location
• Mount the relay module under the helm using the mounting hardware
(2 #8 x 1/2"screws provided) to secure it in place.
• Connect ground (black wire) to ground bus.
• Connect power (orange wire) to a supply capable of a 20A (12V), or 10A (24V).
• Plug the 3 ft. extension cable on the display to the 3 ft. extension cable on the
BCN relay module (If cable length is not long enough, an extension is available
as part number BHW40XX).
Bennett Marine | Bolt Electric Trim Tab System
Green Communications LED
Red Power LED
Starboard actuator up
(black), down (white)
Port actuator up (black),
down (white)
21