Control Testing/Diagnostics - Bennett Marine BOLT129 Installation & User Manual

Electric trim tab systems

Hide thumbs

Table Of Contents

Table of Contents

Starboard (right)

actuator should

extend when

pressed

Yellow LEDs

Starboard (right)

actuator should

retract when pressed

System Startup

• Turn the battery switch back on or reconnect the battery.

• Turn on the gauge switch.

• Turn on the ignition switch.

• Control should power up and the red power LED should be illuminated.

• The green communications LED should be flashing.

• Press the port "Bow Down" button. The starboard red LEDs should illuminate

as the port actuator extends.

• Press the starboard "Bow Down" button. The port red LEDs should illimunate

as the starboard actuator extands.

• Press the port "Bow Up" button. The starboard red LEDs should turn off as the

port actuator retracts.

• Press the starboard "Bow Up" button. The port red LEDs should turn off as the

starboard actuator retracts.

• If the system is not functioning as described above, refer to the troubleshooting

section beginning on page 33.

Bennett Marine | Bolt Electric Trim Tab System