Change A Service Blocking Rule - NETGEAR BR500 User Manual

• Ending Port. In the field, enter one of the following:
- If the service or application uses a range of ports, enter the end port for the
range.
- If the service or application uses a single port, repeat the port number that
you entered in the Starting Port field.
• Service Type/User Defined. In the field, enter the name of the custom service
or application.
10. Specify which devices on your LAN are affected by the rule, based on their IP
addresses:
• Only This IP Address. Enter the required address in the fields to apply the rule
to a single device on your LAN.
• IP Address Range. Enter the required addresses in the start and end fields to
apply the rule to a range of devices.
• All IP Addresses. All computers and devices on your LAN are covered by this
rule.
By default, the All IP Addresses radio button is selected.
11. Click the Add button.
The new rule is added to the Service Table on the Block Services page.

Change a service blocking rule

You can change an existing service blocking rule.
To change a service blocking rule:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter https://www.routerlogin.net.
Your browser might display a security message, which you can ignore. For more
information, see Log in to the local browser interface on page 16.
A login window opens.
3. Enter the router user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. If you didn't change the password, enter password. The user name
and password are case-sensitive.
The Dashboard displays.
Manage the Firewall and
Security
Insight Instant VPN Router BR500
62 User Manual