Remove A Reserved Ip Address Entry For A Lan Subnet; Add And Manage Ipv4 Static Routes - NETGEAR BR500 User Manual

Remove a reserved IP address entry for a LAN subnet

You can remove a reserved IP address entry that you no longer need.
To remove a reserved IP address entry for a LAN subnet:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter https://www.routerlogin.net.
Your browser might display a security message, which you can ignore. For more
information, see Log in to the local browser interface on page 16.
A login window opens.
3. Enter the router user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. If you didn't change the password, enter password. The user name
and password are case-sensitive.
The Dashboard displays.
4. Select BASIC > Setup > LAN Setup.
The LAN Setup page displays for the default LAN subnet (LAN1).
5. If you added another LAN subnet (see Add a LAN subnet on page 76) and want to
remove a LAN IP address entry for that LAN subnet, click the tab for that LAN subnet.
6. In the Address Reservation table, select the radio button for the reserved address.
7. Click the Delete button.
A warning pop-up window opens.
8. Click the OK button.
The IP address entry is removed.

Add and manage IPv4 static routes

Static routes provide detailed routing information to your router. Typically, you do not
need to add static routes. You must configure static routes only for unusual cases such
as when you use multiple routers or multiple IP subnets on your network.
As an example of when a static route is needed, consider the following case:
• Your primary Internet access is through an ADSL modem to an ISP.
Manage the LAN and VLAN
Settings
Insight Instant VPN Router BR500
87 User Manual