Table of Contents
Advertisement
Electrical connections
General information
If your equipment includes an electrical component, please note the
following information to correctly connect the equipment and to
prevent problems when working.
The voltage required by the electrical components is 12 volts (V).
Before connecting any component, make sure that the polarity is
correct.
Red wire = 12 V positive (+)
Black wire = negative (-)
The connectors assembled on the electric components comply with the
standards for the majority of modern tractors.
If your tractor has another type of power supply connector, the supplied
connector will need to be removed and adapted to the tractor connector.
Installing the basic electrical control box
Find a suitable location in the tractor cabin where the control box can
be fitted and operated comfortably. It is recommended that you place it
to the right of the driver's seat.
μ
ATTENTION! The control box must be properly attached to
prevent vibrations and damages.
The connector is an universal type with removable adaptor cap (A) and
it should be able to be connected to any tractor.
As an emergency solution, remove the connector and splice the wires
directly to the battery.
±
WARNING! Always remember: Red wire (+) Black wire (-)
÷
NOTE! Always replace the spare fuse again so a new fuse is
available for future use.
4 - Start up
-
+
Blue
Brown
25
Advertisement
Table of Contents
