METHVEN Maku SatinJet Slide Rail Shower Installation Manual

METHVEN Maku SatinJet Slide Rail Shower Installation Manual

Advertisement

CLEANING

Water contains lime which remains on the
surface after the water has evaporated. These
lime deposits can be prevented from forming by
wiping immediately after use.
Do not use any
shap objects to
clean nozzles

NOTES:

1) Low and unequal systems:
Removal of the flow restrictor with pliers may be
necessary to optimise flow performance in low or
unequal pressure systems only. Flow restrictor is
lodged firmly in the end of the handset.
Methven warrants this product against manufacturing defects and that it is suitable for use
under the operating conditions specified in this instruction sheet.
For your warranty please refer to www.methven.com or call Customer Service
New Zealand
0800 804 222
436932
To clean the chrome-plated surface use a soft
cloth, soap and warm water. Never use cleaning
agents that contain a corrosive acid or a scouring
additive.
Clean filter washer
periodicallly
Australia
1300 638 483
0800 195 1602
MAKU SATINJET SLIDE RAIL SHOWER
INSTALLATION GUIDE

TECHNICAL SPECIFICATIONS

Operating Pressure:
Min 35 kPa, Max 500 kPa.
Recommended installation of a pressure
limiting valve if supply exceeds 500kPa.
Operating Temperature:
Max 70°C.
NB: New Zealand Building Code Clause G12 -
Water Supplies specifies all outlets used
primarily for personal hygiene shall deliver
water at a safe temperature.
Inlet Connections: All ½" BSP.
UK
Issue A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Maku SatinJet Slide Rail Shower and is the answer not in the manual?

Questions and answers

Ian bradley
January 29, 2025

What tool do I need to remove the grub screw?

1 comments:
Mr. Anderson
February 10, 2025

The document does not specify the exact tool needed to remove the grub screw on the METHVEN Maku SatinJet Slide Rail Shower. However, grub screws are typically removed using an Allen key (hex key).

This answer is automatically generated

Summary of Contents for METHVEN Maku SatinJet Slide Rail Shower

  • Page 1 Flow restrictor is lodged firmly in the end of the handset. Methven warrants this product against manufacturing defects and that it is suitable for use under the operating conditions specified in this instruction sheet. For your warranty please refer to www.methven.com or call Customer Service...
  • Page 2 Fit the internal mounting grub screw topside brackets by locating in slot and rotating 90° as shown. Maku Handset Wall Boss Housing NOTE: ENSURE PROTECTION Internal Mounting Bracket PADS ARE USED Slider BETWEEN WALL BOSSES AND TILES Hose Orientate rail so that Rail pre-fitted endcap is at bottom of rail...

Table of Contents