Table of Contents
Advertisement
Chapter 3 Basic operation
42
Network Board firmware updating
Updates the firmware of the Network Board on the multiple targets all at once.
Before taking the procedure below, put a supplied binary file "****.bin" on the desktop of your
computer.
1. Select a target you intend to update the firmware of the Network Board. If you select a top server
or a server which has the targets, the targets under the selected server are targets to update
the firmware of the Network Board. Also you can select multiple targets on the status list view
window individually.
2. Select PJ-Net Update from Update menu.
3. Browse and select a prepared "****.bin" file on the desktop.
4. Click Open, and then the another confirmation dialog will appear.
5. Click Condition if you want to set condition command, or click OK if you want not to set the
condition command.
Take below steps if you click Condition.
5-1.The window to set the condition to execute the updating appears. This is the same setting
window used in the PJ Global Setting or PDP Global Setting.
5-2.Tick check box next to the command name you want to use for condition check.
* To make a new condition check command, click Add to open the edit condition window
and enter command and status, and set retry on or off. See item "Condition setting" (p.33)
for further details. Click OK to set a new condition.The setting window closes.
5-3. Click OK to start updating.
The updating command is sent to all the target servers and each server starts updating the firmware
of the targets sequentially.
* To check that the firmware of the Network Board was updated successfully, check the version indication
on "PJ-Net Ver. " column on the status list view window.
* If there are disconnected servers during command executing, the upper server monitors connection
status every 1 minute and keeps command until the command delivers to all the linked servers.
* Updating is only executed when the ID in the update file coincides with the Network Board ID.
* For further information of the binary update file, please consult your sales dealer.
Condition
Command: CF PJ-NET VERSION
Status:001.001
Retry: OFF
Advertisement
Table of Contents
