Connect Interface Cable - Huawei Quidway Eudemon 200 Installation Manual

Installation Manual
Quidway Eudemon 200 Firewall
Figure 7-6 T1 cable
In addition, you may choose to extend the T1 cable by using a network interface
connector that has an RJ-45 receptacle at each end.
Note:
Both T1 cable and network interface connector are optional accessories. You should order them together
with the 4T1. Otherwise, they will not be provided.
For the pinouts of these cables, please refer to Appendix A.

7.7.5 Connect Interface Cable

Caution:
You must connect a cable to the interface with the appropriate mark. Misplugging is prone to impair the
interface module and even damage the interface module mainframe.
In the event that the T1 cable is led outdoors, you are recommended to install a special lightning
arrester at the input end of the T1 cable for the purpose of achieving a better lightning protection effect.
Step 1: Insert one end of the T1 cable into the RJ-45 connector of the interface module.
Step 2: Connect the other end of the cable to the peer equipment.
Directly connect the T1 cable to the peer equipment if the cable is long enough.
Extend the T1 cable if it is not long enough, as shown in Figure 7-7.
7-16
Chapter 7 Interface Module