Adjusting The Fan Speed - Sanyo KHS2432 Instruction Manual

NOTE
3. Adjusting the
Fan Speed
A. Automatic
Cooling mode:
Heating mode:
NOTE
B. Manual
OI-212-15EG
Operation with the Remote Control Unit (continued)
Choose the best position in the room for the remote control unit, which
•
also acts as the sensor for room comfort and transmits the operating
instructions. Once you've found this best position, always keep the
remote control unit there.
This appliance has a built-in 3-minute time delay circuit to ensure
•
reliable operation. When the operation button is pressed, the
compressor will start running within three minutes. In the event of
power failure, the unit will stop. When the power is restored, the unit
will restart automatically after three minutes.
Simply set the FAN SPEED selector button to the
A microcomputer in the air conditioner controls the fan speed automatically
when the mode is selected. When the air conditioner starts operating,
the difference between the room temperature and the set temperature is
detected by the microcomputer which then automatically switches the fan
speed to a suitable level.
When difference between
room temperature and set
temperature is
4 °F and over
Between 4 °F and 2 °F
Below 2 °F
When difference between
room temperature and set
temperature is
4 °F and over
Below 4 °F
The above table assumes that the sensor in the remote control is being
used. If the sensor in the indoor unit is being used (the
actual operation may differ slightly from the operation described in the
table.
(Refer to ''SENSOR button'' on page 10.)
If you want to adjust fan speed manually during operation, just set the FAN
SPEED selector button as desired by following STEP 4 on page 14. [
, or ]
position.
FAN SPEED
High
Medium
Low
FAN SPEED
High
Medium
indicator is on),
,
15