Adjusting The Fan Speed - Sanyo SAP–K91AA Technical & Service Manual

NOTE
2. Adjusting the
Fan Speed
A. Automatic
Cooling and DRY mode:
NOTE
B. Manual
OI-005-13EG
Operation with the Remote Control Unit (continued)
This appliance has a built-in 3-minute time delay circuit to ensure
•
reliable operation. When the operation button is pressed, the
compressor will start running within three minutes. In the event of
power failure, the unit will stop. When the power is restored, the
unit will restart automatically after three minutes.
Simply set the FAN SPEED selector to the
A microcomputer in the air conditioner automatically controls the fan
speed when the mode is selected. When the air conditioner starts
operating, the difference between the room temperature and the set
temperature is detected by the microcomputer which then automatically
switches the fan speed to the most suitable level.
When difference between
room temperature and set
temperature is
2 ˚C and over
Between 2 ˚C and 1 ˚C
Below 1 ˚C
The above table assumes that the sensor on the remote control is being
used. If the sensor on the indoor unit is being used (the
actual operation may differ slightly from the operation described in the
table.
(Refer to "A/C SENSOR button" on page 9.)
If you want to adjust fan speed manually during operation, just set the
FAN SPEED selector as desired. [
position.
FAN SPEED
High
Medium
Low
, , or ]
indicator is on),
13