Sanyo KHS2432 Instruction Manual page 23

How to remove the filter
How to remove the filter
How to clean the filter
Outdoor Unit
CAUTION
Care: After a Prolonged Idle
Period
Care: Before a Prolonged Idle
Period
OI-212-23EG
Care and Cleaning (continued)
Ceiling-mounted type:
1. Remove the bolt screws on the latch using a screwdriver. (After
cleaning, be sure to reattach the two bolt screws.)
2. Take hold of the two latches on the air intake grille and press them to
the rear, and the grille will open downward.
3. Take hold of the finger-hold on the air filter, first lift it and then pull it
toward you to release it from the catch.
Air filter
Wall-mounted type
1. Move the flap on the air outlet grille to its lowest position.
2. Hold the air filter by the tab at the bottom, and pull downward.
Pull down
Use a vacuum cleaner to remove light dust. If there is sticky dust on the
filter, wash the filter in lukewarm, soapy water, rinse it in clean water, and
dry it.
1. Certain metal edges and the condenser fins are sharp and may
cause injury if handled improperly; special care should be taken
when you clean these parts.
2. Periodically check the outdoor unit to see if the air outlet or air
intake is clogged with dirt or soot.
3. The internal coil and other components of the outdoor unit must
also be cleaned periodically. Consult your dealer or service center.
Check the indoor and outdoor unit air intakes and outlets for blockage; if
there is a blockage, remove it.
Operate the fan for half a day to dry out the inside.
•
Disconnect the power supply and also turn off the breaker.
•
Clean the air filter and replace it in its original position.
•
Outdoor unit internal components must be checked and cleaned
•
periodically. Contact your local dealer for this service.
Latch
Air intake grille
Air filter finger-hold
Air filter
Catch
23