Siemens SIMATIC PP7 Equipment Manual page 34

Mechanical instal-
lation of the Push
Button Panel
Front panel thickness: max. 6 mm
4-2
www.gkbpx.com
Step
1 Insert the Push Button Panel from the front in the mounting cut-
out provided.
2 Insert the retaining hooks of the five enclosed screw-type clamps
in the corresponding openings in the Push Button Panel
housing. Alternative openings are provided on the sides of the
Push Button Panel to enable the installation of several units beside
each other without leaving any gaps between them.
Front panel
3 Secure the Push Button Panel in the front panel
using a screwdriver. Note:
– Do not overtighten the screws to avoid damage.
Front panel
Action
Push
Button
Panel
from the rear
Push
Button
Panel
PP7, PP17-I, PP17-II Equipment Manual
Release 06/98
该文档是极速PDF编辑器生成，
如果想去掉该提示,请访问并下载：
http://www.jisupdfeditor.com/