Siemens SIMATIC PP7 Equipment Manual page 21

The special GSD files transfer information concerning the Push Button Panel
to the configuration software COM-PROFIBUS (SIMATIC S5) and HW-
CONFIG (SIMATIC S7). Older versions of the configuration software do not
contain these GSD files. For this reason, a disk is enclosed with the manual
which contains the current GSD files for the Push Button Panel.
The following procedure is recommended in respect of the GSD files:
PP7, PP17-I, PP17-II Equipment Manual
Release 06/98
www.gkbpx.com
Step
1 Check whether your system is already provided with the special
GSD file required for your Push Button Panel. To do this, call in
the configuration software COM-PROFIBUS (SIMATIC S5) or
HW-CONFIG (SIMATIC S7).
COM-PROFIBUS
(SIMATIC S5)
HW-CONFIG
(SIMATIC S7)
If the corresponding entry already exists, the system already con-
tains the GSD files. In this case, skip the points 2 and 3 of these
instructions.
2 If the respective entry is not available in COM-PROFIBUS
(SIMATIC S5) or HW-CONFIG (SIMATIC S7), the GSD files
relevant to your Push Button Panel must be loaded in the system.
The GSD files for the Push Button Panels are contained on the disk
enclosed with this manual.
COM-PROFIBUS
(SIMATIC S5)
HW-CONFIG
(SIMATIC S7)
Check whether an entry exists in the hard-
ware family SIMATIC or SIMATIC PP for
your Push Button Panel.
Check whether an entry exists in the hard-
ware catalog under PROFIBUS-DP/
ADDITIONAL FIELD DEVICES/
SIMATIC for your Push Button Panel.
Copy:
1. all the files from directory GSD on the
disk to subdirectory GSD in the COM-
PROFIBUS installation, and
2. all the files from directory BITMAPS
on the disk to subdirectory BITMAPS
in the COM-PROFIBUS installation.
Copy:
1. all the files from directory GSD on the
disk to the path S7DATA/GSD in the
STEP 7 installation, and
2. all the files from directory BITMAPS
on the disk to the path S7DATA/
NSBMP in the STEP 7 installation.
该文档是极速PDF编辑器生成，
如果想去掉该提示,请访问并下载：
http://www.jisupdfeditor.com/
2-7