Wall-Mounted Type (K Type) - Sanyo 85464359982001 Installation Instructions Manual

W-2way system air conditioner
Table of Contents

Advertisement

07-007 W-2WAY_II_NA
1/23/07

9-5. Wall-Mounted Type (K Type)

I
NAME OF PARTS
K Type (Wall-Mounted)
I
CARE AND CLEANING
WARNING
Air intake and outlet side
(Indoor unit)
CAUTION
Air filter The air filter collects dust and other particles from the air and should be cleaned at regular intervals
Type
Period
K
2 weeks
<How to clean the filter>
<How to remove the filter>
6:09 PM
Page 93
1. For safety, be sure to turn the air conditioner off and also to disconnect the power before
cleaning.
2. Do not pour water on the indoor unit to clean it. This will damage the internal compo-
nents and cause an electric shock hazard.
Clean the air intake and outlet side of the indoor unit with a vacuum cleaner brush, or wipe them
with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with a mild liquid detergent. When clean-
ing the air outlet side, be careful not to force the vanes out of place.
1. Never use solvents or harsh chemicals when cleaning the indoor unit. Do not wipe plastic
parts using very hot water.
2. Some meta l edges and the fins are sharp and may cause injury if handled improperly; be
especially careful when you clean these parts.
3. The internal coil and other components of the outdoor unit must be cleaned every year.
Consult your dealer or service center.
as indicated in the table below or when the filter indication (
unit (wired type) shows that the filter needs cleaning. If the filter gets blocked, the efficiency of the air
conditioner drops greatly.
NOTE
The frequency with which the filter should be cleaned depends on the environment in which the
unit is used.
1. Remove the air filter from the air intake grille.
2. Use a vacuum cleaner to remove light dust. If there is sticky dust on the filter, wash the filter in
lukewarm, soapy water, rinse it in clean water, and dry it.
1. Move the flap on the air outlet grille to its lowest position with the remote control unit.
2. The filter is disengaged by pushing the tab up gently. Hold the air filter by the tab at the bottom,
and pull downward.
Air intake grille
When replacing the filter, make sure that the FRONT mark is facing you.
Push it up until you hear it click back into position.
Air intake
Air outlet
) on the display of the remote control
Air filter
93
K

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents