Ceiling Mount Installation - Draytek VigorAP 910C Quick Start Manual

3.1 Ceiling-mount Installation
For a wooden ceiling, you can use self-tapping screws to fix the mounting bracket
without any other fixings. The screws go through the bracket and then directly into
the wood; no 'wall-plug' fixing needs to be used
For ceilings made of plasterboard, you
can use the self-tapping fixings. Hold the
bracket up to the ceiling to mark the
locations for the screw holes with a pencil
then set the bracket aside.
Hammer the fixings lightly to allow the
sharp end to penetrate the plaster and start
the hole, then gently screw the fixing into
the plasterboard with a manual, not
electric, screwdriver (seek professional
help if you are not experienced with these
fixings).
For solid ceilings (e.g. concrete) you will need to assess and provide appropriate
fixing hardware; this is not included with the product.
Warning: The screw set shown below is for wall mounting only. Do
not use it for ceilings as it may not provide adequate support.
With all types of fixing, during installation, always use appropriate
personal safety protection and check for visible or hidden hazards
(cables, joists, pipes) before drilling or fixing. Consult a qualified
installer if you are not experienced.
.
.