Recorded Data; Application - ABB COM600 series User's & Technical Manual

1MRS758734
4.5.
4.6.
COM600 series 5.1
Substation Analytics Technical Manual
for example "Phase Grp 1", "Phase Grp 2" and "Phase Grp 3". One of the groups to be
used with the Base value Sel phase setting must be selected.

Recorded Data

General
All the information required later for fault analysis is recorded when the recordingfunction
of SCEFRFLO is triggered. The triggering can be either internal or external.
Table 4.5-1 Recorded data of the SCEFRFLO
Parameter name
1 Recording time
1 FAULT_LOOP
1 RF
1 RFLOOP
1 XFLOOP
1 FLT_DISTANCE
1 UNSUPP_TIME
1 FLT_PHASE
1 FLT_TYPE
1 VALIDITY_CALC
1 FLT_DIST
1 VALIDITY
1 Breaks
1 CB_OPEN_OR_APP_TIME
1 SOURCE_LN
1 IED_NAME
1 FLOC_READY_TIMESTAMP

Application

The main objective of line protection and monitoring terminals is fast, selective and
reliable operation for faults on a protected line section. Besides this, information on the
distance to fault is very important for those involved in operation and maintenance.
Description
Record data of bank 1 for trigger time stamp
Record data of bank 1 for fault loop
Record data of bank 1 for fault resistance
Record data of bank 1 for fault loop resistance
Record data of bank 1 for fault loop reactance
Record data of bank 1 for fault distance
Record data of bank 1 for Unsupported time
Record data of bank 1 for Fault phase
Record data of bank 1 for Fault type
Record data of bank 1 for Validity of the calcu-
lation
Record data of bank 1 for fault distance
Record data of bank 1 for Validity
Record data of bank 1 for Breaks
Record data of bank 1 for the CB open or
Application time
Record data of bank 1 for the source logic node
Record data of bank 1 for the IED name
Record data of bank 1 for the fault location
ready time stamps
37