Dimms; Removing A Dimm - Compaq ProLiant BL20p Maintenance And Service Manual

DIMMs

To remove a DIMM:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
"Server Blade Preparation" section in this chapter.
2. Remove the access panel. Refer to the "Access Panel" section in this chapter.
NOTE: The server blade ships with at least two DIMMs installed in slots 1A and 2A.
3. Open the DIMM slot latches (1).
4. Remove the DIMM from the slot (2).
Figure 2-6: Removing a DIMM
IMPORTANT: Always install DIMMs in identical pairs.
IMPORTANT: DIMMs do not seat fully if turned the wrong way.
Reverse steps 1 through 4 to replace a DIMM.
Compaq ProLiant BL20p Server Blade Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: AvalancheX Part Number: 316080-001 Last Saved On: 12/18/02 11:31 AM
1
2
CAUTION: For proper DIMM configuration, refer to the setup and installation guide.
CAUTION: Use only Compaq DIMMs. DIMMs from other sources may adversely affect data
integrity.
Removal and Replacement Procedures
1
2-9