Samsung Galaxy Note9 Basic Manual page 31

• Do not wear gloves, etc. when you attach or remove the au IC
card/microSD memory card tray. Even a fine debris (a piece of
hair, etc.) between contact surfaces may allow water to enter
the interior of the product. If there is any water droplets or
debris on the tray, wipe them off completely with a dry clean
cloth before attaching it.
• Deterioration or damage of the au IC card/microSD memory
card tray will cause the waterproof performance to degrade.
How to attach the au IC card/microSD memory card tray
Insert the au IC card/microSD memory card tray in a straight
line all the way into the au IC card/microSD memory card slot
as shown in the diagram.
• If you turn the au IC card/microSD memory card tray upside down, the
au IC card may be dislodged.
● If any liquid other than water gets on the product
• In the event that the product comes into contact with liquid
other than water (seawater, detergent water, alcohol, etc.),
rinse it off immediately.
• You can wash the product under a mild flow (less than 6 liters
per minute) of tap water at room temperature (5℃ to 35℃ ) at
a distance of about 10 cm from the faucet or shower head.
• If the product gets dirty, wash it with your hands holding the
au IC card/microSD memory card tray so that it does not
open. Do not use a brush or sponge.
● If the product gets wet
• After the product gets wet, drain water and wipe the product
with a clean dry cloth.
• Water droplets adhered on the product may freeze in cold regions.
Continued use of the product in such condition may cause
malfunctions. Do not leave any water droplets on the product.
● Use in the bath
• This product can be used in the bath. You can have phone
calls with wet hands, but do not put it into the bathtub. This
product is not heat-resistant.
• Do not use it for long periods of time in the bathroom. This
product is not water-resistant.
• Do not immerse the product in spas or water with soap,
detergent, or bath salts in it. Additionally, do not use the
product underwater. Doing so might cause a fault.
• Rapid changes in temperature may cause condensation. If
you are going to take this device from a cold place to a warm
place, such as a bathroom, wait for the device to be at room
temperature before taking it to a warm place.
• If condensation forms inside the display, keep the device at
room temperature until the condensation dissipates.
• Do not splash hot water on the device. It is not heat-resistant.
• Do not connect earphones or external devices to the device in
the bathroom.
• Do not charge the device in the bathroom.
29