Charging Set Up - Ergotron 48 Unit Management Cart Manual

Tablet Charging Set-up
1
Make sure the cart power cord is
disconnected from wall power supply
before proceeding.
Unlock the module and open the doors.
NOTE: the cart power cord acts as the
connect/disconnect device switching
power off and on.
2
Use a Phillips screwdriver to remove the two
screws located on the interior sides of the
module; save screws to reinsert later.
3
Partially slide out the module drawer. You'll
need to unplug two cables before sliding the
drawer completely out. Open the strap to
access the two cables.
4 of 12 888-83-078-G-00 rev A • 11/16