ResMed AirFit F10 User Manual

Fitting guide for AirFit F10
1 2
• Remove the elbow from the mask by • Take off the lower headgear straps and hold
pressing the side buttons and pulling it out. the cushion to the face. Align the bottom
with the crease of the chin and the top
with the corner of the eye.
• Then pull the headgear over the head.
4 5
• Bring the lower straps below the ears and • Adjust the lower headgear straps evenly
loop the headgear into the lower hooks on until the mask feels stable.
each side of the frame.
• The fitting should be firm yet comfortable.
Do not over-tighten.
7
• Undo the tabs on the upper headgear straps. Additional options
• Reposition both straps evenly, only enough
• Position the lower part of the headgear over or under the hair to suit the hairstyle preference.
so a seal is achieved, then reattach the tabs.
• Optional soft sleeves may be assembled for even more comfort on the cheeks.
• The mask is now ready to use.
Optimal cushion positioning
3 1
• Undo the fastening tabs on the upper
headgear straps.
• Adjust both straps evenly until the mask
feels stable, then reattach the tabs.
6
Align the bottom of the cushion with the crease
of the chin and the top of the cushion with the
• Connect device air tubing to the elbow, then corner of the eye.
attach the elbow to the mask by pressing in
the side buttons, then push it into the mask.
• Turn on the device so it blows air.
• The patient now lies down to make any
final adjustments if required.
ResMed internal study of existing ResMed patients, conducted between 25 July and 4 September, 2013 comparing their ResMed traditional full face mask with AirFit F10.
*
ResMed Ltd
1 Elizabeth Macarthur Drive
Bella Vista NSW 2153 Australia
ResMed.com
Note: For more details, refer to the AirFit F10 User Guide.
2
AirFit F10 sits on the nose at, or below, eye level.
Distributed by: ResMed Ltd, Bella Vista, NSW, Australia. See ResMed.com for ResMed locations worldwide. AirFit, SoftEdge and Spring Air are
trademarks of ResMed Ltd. SoftEdge and Spring Air Technology are registered in the U.S. Patent and Trademark Office. Product availability may vary
across regions. Specifications may change without notice. © 2014 ResMed Ltd. 1017249/2 2014-03
Full face benefits in a compact size
ResMed's AirFit™ F10 full face mask is part of ResMed's AirFit range – the right fit for you.
Its lightweight, streamlined design enhances comfort and ease-of-use, while its headgear
and frame work in synergy, to deliver the same performance and stability you have grown to
trust in a ResMed traditional full face mask.
Proven performance
Superior comfort
The dual-wall Spring Air cushion
AirFit F10's sleek, lightweight design ™
provides a secure seal for better
gives patients a clear line of sight so they
performance. When asked about
can read, watch TV or even wear glasses
AirFit F10's seal and stability, the
while wearing the mask. In fact, 75%
majority of patients we spoke to, told
of patients found AirFit F10 to be more
us that it outperformed their ResMed
comfortable than their current ResMed
traditional full face mask. *
traditional full face mask. *
Ease-of-use
The mask's four-part design makes
it easy for you to demonstrate and
for patients to take apart, clean and
reassemble. Its intuitive design
seamlessly integrates into your
patient's bedtime routine.
ResMed.com