Roller; Crisper Drawers - GE ETS series Technical Service Manual

Fresh Food Door
1. Remove all food from the inner door liner.
Note: Do not lose plastic washers on center
hinge pin and lower hinge pin. Plastic washers
are needed for proper door adjustment.
2. Remove pin and washer from center hinge.
Plastic Washer
Hinge Pin
Center Hinge
Bracket
3. Open the door and lift it off the bottom hinge to
remove.
Rollers
Rollers at the base of the cabinet enable the
customer to easily move the refrigerator. Cabinet
leveling is done by adjusting the front rollers. To
adjust the front rollers, use a 3/8-in. socket or a
large flat head screwdriver to turn the roller
adjustment screws located behind the base grille.
The rear rollers are not adjustable.
Fresh Food Door
GEA01147
To remove a front roller assembly from the base of
the cabinet:
1. Tilt the cabinet back and place a
3-in. block under the side of the unit.
2. Remove 3 hex head (1/4-in.) screws from the
roller assembly.
3. Loosen the adjustment screw until it
disengages from the assembly and remove
the assembly from the cabinet.
4. Remove the E-ring to remove the adjustment
screw from the base channel.
Note: When reinstalling the roller assembly,
position the nut with the flared thread toward the
rear of the unit.

Crisper Drawers

Unload the bottom shelf before attempting to
remove the storage drawers.
To Remove:
Lift the drawers up slightly while pulling
them past the stop location.
When the door cannot be fully opened:
Remove the drawer that is farthest from the door.
Slide the other drawer toward the middle and
remove it.
– 10 –