Evaporator Fan; Condenser Fan - GE ETS series Technical Service Manual

Cut Cut Cut
Here Here Here
Copper Copper Copper
Cut Cut Cut
Evaporator Evaporator Evaporator
Here Here Here
Lines Lines
OLD EVAPORATOR
Defrost Defrost Defrost
Thermostat Thermostat Thermostat
Here Here Here
Cut Cut Cut
Here Here Here
Copper Copper Copper
Evaporator Evaporator Evaporator
Cut Cut Cut
Lines Lines
Here Here Here
NEW EVAPORATOR
Note: Evaporator drain probe assists in defrosting
drain. During assembly, probe must be installed on
evaporator and in drain to prevent drain from
freezing closed.
8. Install a replacement dryer.
9. Evacuate and recharge the system using
currently accepted procedures.
Aluminum Aluminum Aluminum
Evaporator Tubes Evaporator Tubes Evaporator Tubes
1-1/8 inch
1-1/8
inch
Aluminum Aluminum Aluminum
Evaporator Tubes Evaporator Tubes Evaporator Tubes
GEA01108

Evaporator Fan

1. Remove the evaporator cover (see Air tower
and Evaporator Cover procedure).
2. Disconnect the fan motor connector.
3. Carefully pull the fan off the shaft.
4. Remove 2 screws and fan assembly.
5. Remove fan motor.
Note: The position of the fan blade in relation to
the shroud is critical. Refer to figure below for
specifications.
5/16" ± 0.03
Blade tip
1.0" ± 0.05 Target

Condenser Fan

1. Remove the machine compartment cover.
2. Disconnect the fan motor connector.
3. Carefully push the fan off the motor shaft.
– 14 –
Orifice
Airflow
Air Flow
Motor
GEA01149