Replacing The Front Wheel Bearing - KTM 990 Adventure Repair Manual

1
2
6
4

Replacing the front wheel bearing

– To dismount the front wheel, see page 10-2.
– Pull out both distance bushings
of the hub and take the lock ring
pliers.
– Push the bearing spacing tube
bearing
– Take the bearing spacing tube out of the hub and knock out the
second grooved ball bearing
– Press a new grooved ball bearing
tool.
5
W
HEN YOU PRESS IN THE BEARING
3
I
F YOU PRESS THE INNER RING
BALLS WILL BE DAMAGED
2
– Insert the bearing spacing tube in the hub and press in the grooved
1 ball bearing
bearing ring.
– Mount the lock ring
in with the back of 584.29.091.000 until flush.
– Attach both distance bushings
NOTE: the collared bushing must be mounted on the left.
– To remount the front wheel, see page 10-2.
, pry both shaft seal rings
1
aside and knock the grooved ball
4
out from the opposite side with a driver.
5
.
6
! CAUTION
,
MAKE SURE TO PRESS THE OUTER RING ONLY
,
THE BALLS OR THE BEARING SURFACES OF THE
.
, again making sure that you only press the outer
5
, grease the new shaft seal rings
3
.
1
10-4
2
out of the hub with suitable
3
into the hub with a suitable
6
!
and press
2
out
.