Replacing A Front-Loading Nvme Ssd; Front-Loading Nvme Ssd Population Guidelines - Cisco APIC M3 Installation And Service Manual

Replacing a Front-Loading NVMe SSD

b) With the ejector lever on the drive tray open, insert the drive tray into the empty drive bay.
c) Push the tray into the slot until it touches the backplane, and then close the ejector lever to lock the drive in place.
Figure 15: Replacing a Drive in a Drive Tray
Ejector lever
1
Release button
2
Replacing a Front-Loading NVMe SSD
This section is for replacing 2.5-inch or 3.5-inch form-factor NVMe solid-state drives (SSDs) in front-panel
drive bays. To replace HHHL form-factor NVMe SSDs in the PCIe slots, see
NVMe Solid State

Front-Loading NVMe SSD Population Guidelines

The front drive bay supports 2.5- inch NVMe SSDs.
Cisco APIC M3/L3 Server Installation and Service Guide
36
Drives.
Drive tray screws (two on each side)
3
Drive removed from drive tray
4
Maintaining the Server
Replacing HHHL Form-Factor