BMW iDrive Owner's Manual page 125

6. Select "WLAN".
7. The name of the snap-in adapter is speci‐
fied in the "SSID" field. This name can be
individualized if you wish.
8. Do not change any other settings.
Resetting the WLAN settings
The WLAN settings of the snap-in adapter are
reset to the factory settings. The configuration
must be performed again.
Press the WLAN button for approx.
15 seconds until the lower LED above
the button flashes red. Then release the but‐
ton.
Switching the WLAN on and off at the
snap-in adapter
To switch on: press the WLAN button
until the lower LED lights up green.
To switch off: press the WLAN button until the
lower LED flashes green and then goes out.
What to do if...
▷ A connection cannot be established to the
Internet.
Check whether the WLAN is switched on
at the snap-in adapter and the device.
▷ The WLAN is switched on at the snap-in
adapter and at the device but a connection
cannot be established to the Internet.
The UMTS network may be overloaded. In
this case, switch manually to a different
network, refer to page 122, GSM.
Online Edition for Part no. 01 40 2 926 935 - X/13
Telephone in the rear
Status indicator LEDs
Upper LED Meaning
above the WLAN
button
Lights up or‐ Internet connection via
ange. GSM, 2G.
Lights up green. Internet connection via
UMTS, 3G.
Lower LED Meaning
above the WLAN
button
Is not lit. WLAN is deactivated.
Lights up green. WLAN is activated.
LED above the Meaning
Bluetooth button
Lights up green. The Bluetooth connection
to the vehicle, handset or
mobile phone is activated.
Lights up or‐ The text message mem‐
ange. ory is full.
Communications
125