Related Manuals for AEM 21-814C
Summary of Contents for AEM 21-814C
- Page 1 ® Equipped with AEM Dryflow™ Filter No Oil Required! INSTALLATION INSTRUCTIONS PART NUMBER 21-814C (GUN METAL GRAY FINISH) 2017-18 TOYOTA COROLLA 1.8L...
- Page 2 ITEM NO. PART NUMBER DESCRIPTION QTY. 21-2127DK AIR FILTER; 2-3/4" X 5" OVAL DRYFLOW 2-1597C Tube; 2.50” X 32” L, 2017 Toyota Corolla 084018 Hose; 2.50”ID x 2.50” L Hump Reinforced 8-197-1 Extension Harness; 5 Pin 18” Denso 9440 Hose Clamp; 2.15”-3.00” 9448 Hose Clamp;...
- Page 3 Read and understand these instructions BEFORE attempting to install this product. Failure to follow installation instructions and not using the provided hardware may damage the intake tube, throttle body and engine. If you need any assistance please call1-800-858-3333 to speak with a representative in our Customer Service Center before returning the product.
- Page 4 e. Loosen the clamp to the throttle body, unlatch f. Unlatch the wiring harness from the air box, then the clips that hold the air box lid, and disconnect the remove the 3 bolts that hold the lower air box PCV hose.
- Page 5 When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed to do so. a. Install the coupler on the throttle body with the b. Install the MAF sensor onto the AEM intake tube included hose clamps. Tighten the hose clamp on with the supplied M4 fasteners.
- Page 6 e. Secure the battery by tightening the bolt on the f. Lift the vehicle up with a floor jack and secure it core support, then tighten the nut on the battery with jack stands. Remove the 2 bolts and the push strap.
- Page 7 5. Service and Maintenance a. AEM Induction Systems require cleaning the intake system’s air filter element every 100,000 miles. When used in dusty or off-road environments, our filters will require cleaning more often. We recommend that you visually inspect your filter once every 25,000 miles to determine if the screen is still visible.
- Page 8 The powder coating should ® only be cleaned with a mild soap and water solution. Proof of purchase of both the vehicle and AEM intake system is required for redemption of a warranty claim.
Need help?
Do you have a question about the 21-814C and is the answer not in the manual?
Questions and answers