Download Print this page

AEM 21-8016 Installation Instructions Manual

Brute force intake system 2004 pontiac gto 5.7l ls1 v8

Advertisement

Quick Links

Brute Force
Intake
System
Equipped with AEM DRYFLOW Filter. No oil required
Installation Instructions for:
Part Number 21-8016
2004 Pontiac GTO
5.7L LS1 V8
ADVANCED ENGINE MANAGEMENT INC.
TH
2205 126
Street, Unit A Hawthorne, CA. 90250
Phone: (310) 484-2322 Fax: (310) 484-0152
www.aempower.com
Instruction Part Number: 10-8016
2004 Pontiac GTO LS1 V8 C.A.R.B. E.O. #D-392-28
Brute Force Air Intake Systems that are pending CARB approval are illegal in California except on racing vehicles which may never
be used on public highways.
© Copyright 2008

Advertisement

loading
Need help?

Need help?

Do you have a question about the 21-8016 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AEM 21-8016

  • Page 1 Brute Force Intake System Equipped with AEM DRYFLOW Filter. No oil required Installation Instructions for: Part Number 21-8016 2004 Pontiac GTO 5.7L LS1 V8 ADVANCED ENGINE MANAGEMENT INC. 2205 126 Street, Unit A Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 www.aempower.com...
  • Page 2 Congratulations! You have just purchased the finest Air Induction & Filtration system for your truck at any price! The AEM Brute Force System is the result of extensive development on a wide variety of trucks. It is the most advanced short pipe air intake system on the market. Each system is specifically engineered for its particular application.
  • Page 3 Note: This inlet pipe kit requires the removal and reinstallation of emissions related components. If you are not familiar with the installation and/or the operation of these components then please refer this installation to a qualified professional. 1) Getting started Make sure vehicle is parked on a level surface.
  • Page 4 e) Loosen the three screws holding the top of the air f) The coolant reservoir is held in place by two filter housing to the filter box and remove the top. grommets. Move it by lifting it off the two posts that Next, remove the air filter from inside the box.
  • Page 5 3) Installing the AEM BFS Intake a) On the radiator support there are two holes. Behind b) Install the rubber grommet into the hole in the heat these is a plastic panel that needs to be drilled out to shield as shown.
  • Page 6 e) Carefully slide heat shield into engine bay. Push f) Insert the two supplied ¼” bolts into the holes rubber grommet installed in previous step over the previously drilled in step 3a. Loosely secure with the stud on the strut tower. supplied ¼”...
  • Page 7 MAF on the top. m) Insert the IAT sensor into the grommet. This may n) Install the AEM Brute Force filter on to the end of be eased with the use of some lubrication on the the inlet tube.
  • Page 8 Nylok nut onto the rubber mount. r) Check that the filter is not touching any part of the vehicle. Position the AEM Brute Force intake for best q) Install the supplied heat shield zip-tie into the hole in fitment. Be sure that the pipe or any other component is not in contact with any part of the vehicle.
  • Page 9 For Technical Inquiries E-Mail Us At tech@aempower.com...