Related Manuals for AEM AEM-21-8129DC
Summary of Contents for AEM AEM-21-8129DC
- Page 1 ® Equipped with AEM Dryflow™ Filter No Oil Required! INSTALLATION INSTRUCTIONS PART NUMBER AEM-21-8129DC (Gun Metal Gray) 2015 Ford F-150 5.0L...
-
Page 2: Air Filter
Description Qty. Part Number HEAT SHIELD ASSEMBLY 073182 INTAKE TUBE 27398C AIR FILTER 21-210EDK COUPLER HOSE 08698 FILTER ADAPTER 21512-1 HUMP HOSE 08699 HOSE CLAMP 8697 HOSE CLAMP 9456 EDGE TRIM; 1/16” GAP, 26” L 102459 WASHER, FLAT 08269 BOLT, BUTTONHEAD M6-1.00 X 16MM 07730 M6 SPLIT LOCK WASHER 1-3025... - Page 3 Read and understand these instructions BEFORE attempting to install this product. Failure to follow installation instructions and not using the provided hardware may damage the intake tube, throttle body and engine. Tools Needed: 1. Preparing Vehicle Screw driver a. Make sure vehicle is parked on level surface. 10MM socket b.
- Page 4 ® 3. Installation of AEM intake system. a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed to do so. a. Cut two 9.5” lengths from small edge trim and install b. Install air filter adapter onto heat shield with provided on bottom of heat shield on opposite ends, as shown.
- Page 5 e. Place heat shield into factory lower air box. Do not f. Install included straight hose coupler onto filter adapt- er and secure with provided hose clamp. secure clips until intake tube is in place. g. Install hump hose coupler onto throttle body and se- h.
-
Page 6: Service And Maintenance
5. Service and Maintenance a. AEM Induction Systems requires cleaning the intake system’s air filter element every 100,000 miles. When used in dusty or off-road environments, our filters will require cleaning more often. We recommend that you visually inspect your filter once every 25,000 miles to determine if the screen is still visible. - Page 7 The powder coating should ® only be cleaned with a mild soap and water solution. Proof of purchase of both the vehicle and AEM intake system is required for redemption of a warranty claim.
Need help?
Do you have a question about the AEM-21-8129DC and is the answer not in the manual?
Questions and answers