Handling Cautions; Model And Specifications Check - YOKOGAWA DPharp EJXC80A User Manual

2.

Handling Cautions

This chapter provides important information on how
to handle the transmitter. Read this carefully before
using the transmitter.
WARNING
The codes of the diaphragm seal system
represent a seal system type.
CE and other standard certifications are acquired
for each transmitter section.
Please refer to the designated sections of
each transmitter's users' manual(IM) for these
information as "Installation of an Explosion
Protected Instrument", "EMC conformity standards",
"Pressure Equipment Directive(PED)" and "Safety
Requirement Standards".
Table 2.1 Transmitters Manual List
Diaphragm Applicable
Seal System Transmitter
EJXC80A, EJX110A,
EJAC80E EJA110E,
EJX430A,
EJA430E
EJXC81A, EJX310A,
EJAC81E EJA310E
EJXC50A, EJX530A,
EJAC50E EJA530E
The transmitters are thoroughly tested at the
factory before shipment. When taking delivery of an
instrument, visually check them to make sure that
no damage occurred during shipment.
Also check that all the transmitter mounting
hardware shown in figure 2.1 is included.
If the transmitter is ordered without a mounting
bracket or a process connector, such mounting
hardware will not be included.
Users' Manual(IM)
IM 01C25B01-01E
IM 01C25F01-01E
<2. Handling Cautions>
U-bolt nut
Bolt
Process connector gasket
Process connector
Figure 2.1 Transmitter Mounting Hardware
2.1 Model and Specifications
Check
The model name and specifications are written on
the name plate attached to the case.
Serial No. & Model
Tag
Figure 2.2 Name Plate
2-1
Transmitter
mounting bolt
U-bolt
Mounting bracket
F0201.ai
F0202.ai
IM 01C25W01-01EN